Speco O2P30 Owner's Manual page 28

connected status of router.
> External IP: When you connect a router that supports UPnP
function, this option is displayed. Displays the external IP
address allocated router.
> HTTP port: The default HTTP port number (80) can be changed
to any port within the range 1025 to 65535.
> RTSP port: Check RTSP port. The default port is 554. Other
ports can be selected within the range 1025 to 65535.
Note:
The RTSP port number should not be same as the HTTP port
number.
ARP Ping
> Enable ARP Ping to configure IP address: Check to enable
ARP ping.
• Save: Click this button to confirm the settings.
28
Multicast
RTP (Real-time Transport Protocol) is an internet protocol that allows
programs to manage the real-time transmission of multimedia data,
via unicast or multicast.
Profile
> RTP unicast: When enabled the transmission of the data to
the specified equipment happens on a network specifying a
single address.
> RTP multicast: When enabled it reduces the transmission
load on the camera by making the computer of the same
segment network receive the same transmission data. When
multicast option is checked then select Video Port number,
Audio Port number and Data port number.
- IPv4 address: Set the IP address for RTP multicast.
- Base RTP port: Enter the port number of even number
used for the multicast streaming. Each profile uses
successive 6 port number which starts from [Base RTP
port]. It is initially set to 10000 and you can edit this
between 10000 and 65530.
Operation and settings