Speco O2P30 Owner's Manual page 11

Upgrade & Reset
System Restart
Click the [Confirm] button to restart the IP device. It takes a couple
of minutes for the IP device to restart.
Backup & Restore
> Backup: Make a backup all of the settings.
1. Click the [Backup] button.
2. Click the [Save] button.
3. Follow the instructions on the browser to specify the
folder.
4. Click the [Save] button to save the settings.
> Restore:
1. Click the [Browse] button.
2. Find and open the file in which the configuration setting
data is stored.
3. Click the [Restore] button and the system settings will be
restored and reboot the system.
Operation and settings
Note:
Backup and Restore are intended for use on an IP device
having the same version of firmware. This feature is not
intended for multi-configurations or for firmware upgrades.
Firmware
> Upgrade
1. Click the [Browse] button.
2. Find and open the firmware file.
3. Click the [Upgrade] button to update the firmware.
Note:
When you upgrade the system, it may take few minutes
to finish. Do not close the browser while the upgrade
is in progress. If you close the browser, it may cause a
malfunction. You should wait until the confirmation window
is displayed. When the upgrade is finished, the confirmation
window will be displayed.
> Initialize: The [Initialize] button should be used with caution.
Clicking it will return all of the IP device's settings to the
factory default values, except for the Network settings, PTZ
Protocol and Preset settings. (The option depends on the
model.)
Note:
Refer to "Clear browser's cache" under Troubleshooting.
11