Troubleshooting - FLIR ThermaCAM P45 User Manual

15

Troubleshooting

Problem
The LCD on the remote
control, or the viewfinder,
displays no image at all.
The LCD/viewfinder dis-
plays an image, but it is of
poor quality.
Publ. No. 1557966 Rev. a155 – ENGLISH (EN) – February 6, 2006
Possible reason
The camera may have been switched off
automatically due the settings in the Power
setup dialog box.
The LCD may have been switched off auto-
matically due to the settings in the Power
setup dialog box.
The connector on the remote control cable
may not be properly inserted into the re-
mote control connector camera.
There is no battery in the battery compart-
ment.
There is a battery in the battery compart-
ment, but the battery is depleted.
If you are using the power supply, the
power supply connector may not be prop-
erly inserted into the power connector on
the camera.
If you are using the power supply, the
mains plug may not be properly plugged
in into a mains supply.
If you are using the power supply, the
mains cable may not be properly plugged
in into the power supply.
The level needs to be changed.
The span needs to be changed
The camera needs to be autoadjusted.
The target may be hotter or colder than the
temperature range you are currently using.
A different palette may be more suitable for
imaging the target than the one you are
currently using.
Solution
Press ON/OFF to switch on
the camera.
Press ON/OFF to switch on
the camera.
Verify that the connector on
the remote control cable is
properly inserted.
Insert a fully charged bat-
tery.
Charge the battery.
Verify that the power supply
connector is properly insert-
ed.
Verify that the mains plug
is properly plugged in.
Verify that the mains cable
is properly plugged in.
Change the level.
Change the span.
Autoadjust the camera.
Change the range.
Change the palette.
113
15