Removing The Front Bezel - Gateway 3-Bay mBTX Pro User Manual

Removing the front bezel

To remove the front bezel:
1
2
3
124
CHAPTER 12: Adding and Replacing Components
Caution
Be careful not to pull or damage the hard drive power and data cables when
you remove the metal reinforcing beam/hard drive assembly.
After removing the side panel, remove the metal reinforcing beam/hard drive assembly
by lifting it out of the chassis.
Set the assembly aside as far as the hard drive cables will permit.
Push the four black plastic retainer tabs (indicated by the arrows) on the bezel to disengage
them from the front of the chassis, then pull the bottom of the bezel out from the bottom
of the computer.
Swing the bottom of the bezel out until the tab at the top of the bezel slides out of the
slot in the top of the computer, then remove the bezel.