Sony DCR-TRV820 Service Manual page 11

Self-diagnosis Code
Block Detailed
Function Code
Difficult to adjust focus
E 6 1 0 0
(Cannot initialize focus.)
Zoom operations fault
E 6 1 1 0
(Cannot initialize zoom lens.)
Handshake correction function does not
E 6 2 0 0 work well. (With pitch angular velocity
sensor output stopped.)
Handshake correction function does not
E 6 2 0 1 work well. (With yaw angular velocity
sensor output stopped.)
Symptom/State
– 11 –
Correction
Inspect the lens block focus reset sensor (Pin 9 of CN1551 of
VC-235 board) when focusing is performed when the control dial
is rotated in the focus manual mode and the focus motor drive circuit
(IC1553 of VC-235 board) when the focusing is not performed.
Note: Use the remote commander RM-95 only for the model
without the focus dial.
Inspect the lens block zoom reset sensor (Pin 0 of CN1551 of
VC-235 board) when zooming is performed when the zoom lens is
operated and the zoom motor drive circuit (IC1553 of VC-235
board) when zooming is not performed.
Inspect pitch angular velocity sensor (SE201 of SE-114 board)
peripheral circuits.
Inspect yaw angular velocity sensor (SE202 of SE-114 board)
peripheral circuits.