Installing The Print Drum (Cylinder) - Riso ME 9450 User Manual

Installing the Print Drum (Cylinder)

1
Place the Print Drum (Cylinder) on
the Rail.
Align the mark on the Print Drum (Cylinder)
with the mark on the guide, and place the Print
Drum (Cylinder) horizontally onto the guide.
Note:
• If the Print Drum (Cylinder) was manually
rotated, be sure to turn it back so that
marks align, after it is placed on the guide.
Important!:
• You can set the A4/Letter-R Drum (Cylinder)
only to Print Drum (Cylinder) 1.
2
Return the Print Drum (Cylinder) to
its original position.
Push the Print Drum (Cylinder) in as far as it will
go, and then close the Front Cover.
Important!:
• Do not grasp the Print Drum (Cylinder) Handle
when pushing in the Print Drum (Cylinder).
and
Tip:
When changing the Print Drum (Cylinder) type
When you change the Print Drum (Cylinder) type,
the "Print Drum (Cylinder) Type Confirmation"
Screen is displayed.
Confirm the Print Drum (Cylinder) type with the
following procedure.
F17
Print Drum 1:
!!The Print Drum Type
has been Changed!!
Select the Current
Print Drum Type
1)
Touch the type of the Print Drum (Cylinder)
that was set.
2)
Touch [OK].
The Print Drum (Cylinder) type is confirmed
and printing is possible.
Important!:
• You cannot print until the Print Drum (Cylinder)
type is confirmed.
Replacing Consumables
A3 Drum A4-R Drum
OK
Replacing the Print Drum (Cylinder)
251