Adjusting The Print Position [Print Position Adjustment] [1=2 Alignment] - Riso ME 9450 User Manual

Adjusting the Print Position
[Print Position Adjustment] [1=2 Alignment]
The print position on the paper can be adjusted for each Print Drum (Cylinder).
Adjustment range Vertical direction: ±15mm (±
The positioning may be adjusted while printing is in progress.
Important!:
• After adjusting the print position, print a proof copy to check the result.
p.120
Note:
• The numerical value formed by "Print Position Adjustment" is the target. Set the actual position by verifying and
adjusting the printed material.
• Just after adjusting the print position of only one Print Drum (Cylinder), traces of the previous print position remain,
which may cause blurred printing. If this occurs, make several proofs until the remaining image disappears.
p.120
• When adjusting the print position of both Print Drums (Cylinders) to the same location, you can do so by simply
adjusting one Print Drum (Cylinder). The other will be adjusted to the same print position.
p.118
• Print position adjustment values for each Print Drum (Cylinder) are retained after printing is completed, to be
applied for subsequent master making processes. The values will be retained until the
power is turned off.
Press the ,
move up or down.
1 2
1)
Adjusting the print location for Print Drum (Cylinder) 1
2)
Adjusting the print location for Print Drum (Cylinder) 2
3)
Key
Each press shifts the print position downward in steps of
( / "
about 0.5 mm ).
1
64
Bottom Top
19 / ") Horizontal direction: ±10mm (±
32
, or key to
3 4
5
6
7

Adjusting the Print Position [Print Position Adjustment] [1=2 Alignment]

25
4)
Key
Press the key to move the print image about 0.5 mm
to the left on the paper.
Left Side
Right Side
5)
Key
Each press shifts the print position upward in steps of
( /
about 0.5 mm ").
1
64
Bottom Top
6)
Key/Indicator
Press to return to original position.
When returning the position during printing, press this
key for one or more seconds. When the print position is
in the position before adjustment, the indicator turns on.
7)
Key
Press the key to move the print image about 0.5 mm
to the right on the paper.
Left Side
Right Side
Functions for Printing
/ ")
64
key is pressed or
(
(
/
1 ")
64
/ "
)
1
64
117