Table of Contents
Advertisement
Osburn Matrix Inbuilt Installation and Operation Manual
ATTENTION INSTALLER: When positioning the unit in a fireplace opening prior to the flue
installation, install the wood inbuilt into the opening until the top lip of air jacket is flush with
fireplace facing.
If lag-bolts or anchors are to be used to secure the wood inbuilt, the hole locations should be
marked with the unit in place. Remove the wood inbuilt and locate the anchors.
9.4 FLUE LINER INSTALLATION
The preferred methods for installing the flue liner are found in Section 9.5.1. Use a liner offset
adapter (Section 9.5.2) only as a last resort.
9.4.1 IF THE FLUE LINER DOES ALIGN WITH THE WOOD INBUILT'S FLUE OUTLET, YOU HAVE
TWO OPTIONS
A) Install the flue liner starter adapter, provided with the flue liner. Follow the flue liner
starter adapter manufacturer's instructions.
In order to connect the flue liner starter adapter to the flue outlet, you can install the
brackets with the screws that are in the owner's manual kit.
Using a powered driver, secure the three brackets with the three screws provided (30131)
on top of the wood inbuilt in the three holes in front of the flue outlet. The long end of the
brackets must be attached to the wood inbuilt. Insert the flue liner into the flue collar of
the unit and secure the liner to the brackets with three self-tapping screws (not included).
______________________________________________________________________________ 37
Advertisement
Table of Contents
