Moving And Resizing Measurement Tools; General; Procedure; Setting Local Measurement Parameters For A Measurement Tool - FLIR Exx Series User Manual

15 Working with measurement tools

15.3 Moving and resizing measurement tools

15.3.1 General

You can move and resize measurement tools in various ways.

15.3.2 Procedure

Note
This procedure assumes that you have laid out at least one measurement tool on the screen. An exist-
ing spotmeter is used as an example.
Follow this procedure:
1. To select a measurement tool, tap and hold, or tap and push the navigation pad. This
displays a toolbar.
2. On the toolbar, select one of the following and push the navigation pad:
• Remove spot: Removes the selected spotmeter.
• Move spot: Moves the selected spotmeter.
• Center spot: Centers the spotmeter on the screen.

15.4 Setting local measurement parameters for a measurement tool

15.4.1 General
When you set measurement parameters under Settings, all the parameters for the whole
image are changed.
However, in some situations you may want to change a measurement parameter for one
measurement tool only. The reason for this could be that the measurement tool is in front
of a significantly more reflective surface than other surfaces in the image, or over an ob-
ject that is further away than the rest of the objects in the image, and so on.
For more information about object parameters, see section 20.3.1 Measurement param-
eters, page 42.
15.4.2 Procedure
Note
This procedure assumes that you have laid out at least one measurement tool on the screen. An exist-
ing spotmeter is used as an example.
Follow this procedure:
1. To select a measurement tool, tap and hold, or tap and push the navigation pad. This
displays a toolbar.
2. On the toolbar, select Use local parameters and push the navigation pad.
#T559845; r.15722/15722; en-US
33