11
Configuring Wi-Fi
11.1 General
You can connect the camera in two different ways:
• Most common use: Setting up a peer-to-peer connection (also called an ad hoc or
P2P connection). This method is primarily used with other devices, e.g., an iPhone or
iPad.
• Less common use: Connecting the camera to a wireless local area network (WLAN).
11.2 Setting up a peer-to-peer connection (most common use)
Follow this procedure:
1. On the camera, push the navigation pad to display the menu system.
2. Use the navigation pad to go to Settings.
3. Push the navigation pad.
4. Select Device settings and push the navigation pad.
5. Select Wi-Fi and push the navigation pad.
6. Select Share IRCAMxxxx and push the navigation pad.
Note
•
If the transfer rate is low, this can be due to a crowded frequency band. Try changing the channel to
increase the transfer rate.
•
To enable security settings for the camera network, enable WEP.
11.3 Connecting the camera to a wireless local area network (less common use)
Follow this procedure:
1. On the camera, push the navigation pad to display the menu system.
2. Use the navigation pad to go to Settings .
3. Push the navigation pad.
4. Select Device settings and push the navigation pad.
5. Select Wi-Fi and push the navigation pad.
6. Select Connect to network and push the navigation pad.
7. Select Networks and push the navigation pad right.
8. Select a network by pushing the navigation pad. You typically need to enter a pass-
word to access the network.
Note
To connect to a network that does not broadcast its SSID, select Settings > Add network and set up the
parameters manually.
#T559845; r.15722/15722; en-US
20