12
Handling the camera
12.1 Charging the battery
Note
You must charge the battery for 4 hours before you start using the camera for the first time.
12.1.1 Using the power supply to charge the battery
12.1.1.1 Procedure
Follow this procedure:
1. Connect the power supply cable plug to the power connector on the camera.
2. Connect the power supply mains-electricity plug to a mains socket.
3. Disconnect the power supply cable plug when the battery condition LED indicator is
a continuous green.
12.1.2 Using the stand-alone battery charger to charge the battery
12.1.2.1 Explanation
Type of signal
The blue LED flashes.
The blue LED glows continuously.
12.1.2.2 Procedure
Follow this procedure:
1. Put the battery in the battery charger.
2. Connect the power supply cable plug to the connector on the battery charger.
3. Connect the power supply mains-electricity plug to a mains socket.
4. Disconnect the power supply cable plug when the blue LED on the battery charger is
continuous.
12.2 Turning on and turning off the camera
• Push the
button to turn on the camera.
• Push and hold the
mode. The camera then automatically turns off after 6 hours.
• Push and hold the
#T559845; r.15722/15722; en-US
Explanation
The battery is being charged.
The battery is fully charged.
button for less than 5 seconds to put the camera in standby
button for more than 10 seconds to turn off the camera.
21