Stx Kuw Write Data To Rfid Tag; Stx Kv Verifier Enable/Disable; Stx Kw Memory Configuration, Printable Label Width - Datamax E-Class Mark II Programmer's Manual

STX KuW Write Data to RFID Tag

(Direct Mode – UHF Interface – Hexadecimal Data Only)
This command instructs the RFID device to write data to the tag. It is expected that the
tag transponder will be within the read / write distance of the RFID programming device;
otherwise, a warning will occur and a warning message (Read / Write Fail) will be
displayed.
Syntax:
Where:
Sample:
STX KV Verifier Enable/Disable
This command allows a verifier to be enabled and disabled.
Syntax:
Where:
STX KW Memory Configuration, Printable Label Width
See the <STX>K command for details.

This command will result in a system reset for the EX2.
122
Extended System-Level Command Functions
<STX>KuWabcc...c<CR>
- The number of attempts to locate, erase and program
a
the tag (1 – 9).
- Reserved. Should be 0.
b
- Data to be encoded in the ASCII format. Must be
cc...c
sixteen characters in length. The valid characters are
0-9, A-F.

Must be 16 or 24 characters long.
<STX>KuW10ABCDEF0102030405[CR]
The sample above programs the data
<0xAB><0xCD><0xEF><0x01><0x02><0x03><0x04><0x05> to the
tag, attempting to write one additional time if necessary.
<STX>KVa<CR>
- Y = verifier enable
a
N = verifier disable
Class Series 2 Programmer's Manual