Stx Kub Read Data From Gen2 Tag Section; Stx Kuf Send Rfid Device Firmware Version; Stx Kuj Write Data To Gen 2 Tag Section - Datamax E-Class Mark II Programmer's Manual

STX KuB Read Data from Gen2 Tag Section
This command reads a specific block address of a Gen2 tag.
Syntax:
Where:
Sample:

STX KuF Send RFID Device Firmware Version

This command instructs the RFID device to return the firmware version.
Syntax:
Printer response:
STX KuJ Write Data to Gen 2 Tag Section
This command writes a specific block address of a Gen2 tag.
Syntax:
Where:
Sample:
120
Extended System-Level Command Functions
<STX>KuBaaabbb
- Block address number, where: 000 is kill/access
aaa
section; 001 is EPC section; 002 is Tag ID; and, 003 is
user memory.
- Data offset in word length.
bbb
<STX>KuB001002
The sample above reads the block address 1 at offset word 2,
which is location of the EPC data.
<STX>KuF<CR>
DEVICE VERSION: XXX.XXX.XXX[CR]
<STX>KuJaaabbb<data>
- Block address number, where: 000 is kill/access
aaa
section; 001 is EPC section; 002 is Tag ID; or, 003 is
user memory.
- Data offset in word length
bbb
- Hexadecimal data (must be length of multiples of 4)
<data>
<STX>KuJ001002112233445566778899AABBCC
The sample above writes data "112233445566778899AABBCC" to
block address 1 at offset word 2, which is the EPC data.
Class Series 2 Programmer's Manual