Datamax E-Class Mark II Programmer's Manual page 111

(UM) Units of Measure – See <STX>m (metric) or <STX>n (imperial) for command
details.
(UT) User Terminator – This command allows word wrapping of long character
strings of commands to the next line in a file, for the purposes of readability only. In
the <STX>Kc string, the command UTON must fall somewhere before the first line
terminator. The last command needs to be END, followed by a line terminator (see
the <STX>KcEN command for details).
(VE) Verifier Equipped – This command enables the GPIO for a bar code verifier
(see Appendix J). A (or Y) - automatically senses device presence; if undetected, no
error is generated. E - enables the device, where its presence must be detected;
otherwise, a fault is generated. N or D - disables device detection.
(VT) Verifier Type – This command is reserved for future use.
(WE) WiFi Setup – This command configures the printer for a WiFi connection, as
follows:
Value
A
C
F
I xxx.xxx.xxx.xxx
L
(continued)
Class Series 2 Programmer's Manual
Extended System-Level Command Functions
Parameter
Is the SSID (Access Point name),
where:
y
y = Up to 31 characters, no spaces
Is the Channel number (Adhoc only,
country dependent), where:
x
x = 1 to 14
Is Enable DHCP Fixed Interval
Transmission, where x:
x
1 = Fixed
0 = Exponential
Is the IP Address*, where:
x = 0 to 9
Is the DHCP Acquire Time Limit, where:
x
x = 0 to 255 seconds
WiFi Interpretation Default Value
MACR
1
0
192.168.010.001
150
99