Xerox WorkCentre 3655 User Manual page 181

Solving Print-Quality Problems
When the print quality is poor, select the closest symptom from the following table and see the
corresponding solution to correct the problem. You can also print a Demo Page to more precisely
determine the print-quality problem.
If the print quality does not improve after carrying out the appropriate action, contact your Xerox
representative.
Note: To maintain print quality, the toner cartridge is designed to provide a warning message when
the toner level is low. When the toner cartridge reaches this level, a warning message appears. Once
the toner cartridge is empty, another message prompts you to replace the toner cartridge. The
printer stops printing until you install a new toner cartridge.
Symptom
The output is too light.
Toner smears or print comes off.
The output has stains on the back
side.
Solutions
• To check the toner level, check the control panel, use the print driver, or
CentreWare Internet Services. If the toner cartridge is near empty,
replace it.
• Verify that the toner cartridge is approved for use in this printer, and
replace it as needed. For best results, use a genuine Xerox toner cartridge.
• Ensure that the print quality mode is not set to Toner Saver. Toner Saver
us useful for draft quality output.
• Replace the paper with a recommended size and type, and confirm that
your printer and print driver settings are correct.
• Verify that the paper is dry and that supported paper is used. If not,
change the paper.
• Change the Paper Type settings in the print driver.
In the Printing Preferences of the print driver, on the Paper/Output tab,
change the Paper Type setting.
• If printer is located in a high altitude environment, adjust the altitude
setting of the printer. For details, see
• Change the Paper Type settings in the print driver. For example, change
Plain to Lightweight Cardstock.
In the Printing Preferences of the print driver, on the Paper/Output tab,
change the Paper Type setting.
• Verify that the paper is the correct size, type, and weight. If not, change
the paper settings.
• Verify that the printer is plugged into an outlet that is providing the
correct voltage and power. Review the electrical specification of the
printer with an electrician if necessary. For details, see
Specifications on page 198.
Xerox® WorkCentre® 3655 Multifunction Printer
Troubleshooting
Adjusting the Altitude on page 156.
Electrical
User Guide
181