Installing The Control Panel-8 Hard Drive System - Dell PowerEdge R630 Owner's Manual

Figure 54. Removing and installing the control panel
1. control panel
3. display module ZIF connector
Installing the control panel–8 hard drive system
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Keep the #1 Philips screwdriver ready.
Steps
1. Slide the left side of the control panel into the chassis so that the left tab on the control panel aligns
with the slot on the chassis wall and the top left tab aligns with the slot on the top of the chassis.
2. Pull the display module cable through the opening and into the chassis.
3. Push the right side of the control panel until the top right tab aligns with the top of the chassis and
the panel snaps into place.
4. Using a #1 Philips screwdriver, replace the screw (located at the bottom of the chassis) that secures
the control module to the chassis.
2. notch on chassis front wall (2)
4. display module cable
117