Installing An Expansion Card - Dell PowerEdge R630 Owner's Manual

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Steps
1. Disconnect any cables connected to the expansion card or expansion card riser.
2. To remove the expansion card, lift the expansion-card latch.
3. Grasp the expansion card by its edges and remove it from the expansion-card connector on the
riser.
4. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot
opening and close the expansion-card latch.
NOTE: You must install a filler bracket over an empty expansion slot to maintain Federal
Communications Commission (FCC) certification of the system. The brackets also keep dust
and dirt out of the system and aid in proper cooling and airflow inside the system.
Figure 31. Removing and installing the expansion card
1. expansion connector
3. expansion-card
Next steps
Follow the procedure listed in

Installing an expansion card

Prerequisites
1. Ensure that you read the
2. Follow the procedure listed in
After working inside your
Safety instructions.
Before working inside your
2. expansion card latch
4. expansion-card latch
system.
system.
81