Installing A Hard Drive Into A Hard-Drive Carrier; Removing A 1.8 Inch Hard Drive From A Hard-Drive Carrier - Dell PowerEdge R630 Owner's Manual

Figure 25. Removing and installing a hard drive into a hard-drive carrier
1. screw (4)
3. hard-drive carrier

Installing a hard drive into a hard-drive carrier

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Keep the #1 Phillips screwdriver handy.
Steps
1. Insert the hard drive into the hard-drive carrier with the connector end of the hard drive toward the
back.
2. Align the screw holes on the hard drive with the set of screw holes on the hard-drive carrier.
When aligned correctly, the back of the hard drive is flush with the back of the hard-drive carrier.
3. Attach the screws to secure the hard drive to the hard-drive carrier.

Removing a 1.8 inch hard drive from a hard-drive carrier

Prerequisites
1. Ensure that you read the
2. Remove the hard-drive carrier from the system.
Steps
1. Turn the hard-drive carrier.
2. Pull the rails of the hard-drive carrier and lift the hard drive out of the hard-drive carrier.
72
Safety instructions.
2. hard drive