Back-Panel Features And Indicators - Dell PowerEdge R630 Owner's Manual

Back-panel features and indicators

Figure 8. Back-panel features and indicators—8 hard-drive system (2 PCIe expansion cards)
Item Indicator, Button, or
Connector
1 System identification
button
2 System identification
connector
3 iDRAC8 Enterprise port
4 PCIe expansion card slot
(riser 1)
5 Serial connector
6 Video connector
7 USB connectors (2)
20
Icon Description
The identification buttons on the front and back
panels can be used to locate a particular system
within a rack. When one of these buttons is
pressed, the LCD panel on the front and the
system status indicator on the back blink until one
of the buttons is pressed again.
Press to toggle the system ID on and off. If the
system stops responding during POST, press and
hold the system ID button for more than five
seconds to enter BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup)
press and hold for more than 15 seconds.
Allows you to connect the optional system status
indicator assembly through the optional cable
management arm.
Dedicated management port.
NOTE: The port is available for use only if the
iDRAC87 Enterprise license is installed on your
system.
Allows you to connect a low profile PCIe
expansion card.
Allows you to connect a serial device to the
system.
Allows you to connect a VGA display to the system.
Allows you to connect USB devices to the system.
The ports are USB 3.0-compliant.