Installing The Vga Module - Dell PowerEdge R630 Owner's Manual

Figure 56. Removing and Installing the VGA Module
1. screw
3. VGA module

Installing the VGA module

Prerequisites
NOTE: This procedure applies only to the 8-hard drive system.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Steps
1. Push the VGA module into the chassis and align the threaded screw hole on the VGA module with
the screw hole on the chassis.
2. Using a #2 Philips screwdriver, replace the screw (at the bottom of the chassis) that secures the VGA
module to the chassis.
3. Replace the control panel.
4. Connect the VGA module cable to the VGA module.
2. VGA module cable
4. control panel
121