Recording And Playing; Inserting P2 Cards; Removing P2 Cards - Panasonic aj-spd850p Operating Instructions Manual

Recording and playing

Inserting P2 cards

Note:
Before using the unit for the first time, be absolutely sure
to set the internal clock using setup menu item No.069
(CLOCK SET).
(1) Turn the POWER switch of the memory card
recorder on
(2) Press a card in a P2 card slot until the EJECT
button pops out
(3) Push the EJECT button that has popped out
over to the right
P2 card access LED
• When the P2 card is inserted into the memory card
recorder, its status is indicated by the corresponding
P2 card access LED. For details on these statuses,
refer to "P2 card access LEDs and P2 card status."
• Press the REC and PLAY buttons at the same time to
start recording on the card whose access LED has
lighted orange.
Note:
Even when a second P2 card is inserted into
another slot while the data of one card is
playing, its access LED will remain off and the
other P2 card will not be recognized. The
second card will be recognized after the play
of the first card has been completed.

Removing P2 cards

Do not remove a P2 card while it is being accessed or while
it is being recognized after it has been inserted (while its
corresponding access LED is flashing orange).
(1) Press the STOP button.
If the access LED corresponding to the P2 card you
want to remove is flashing orange, press the STOP
button to make it stop flashing. If it does not stop
flashing, hold the STOP button down until it does.
(2) Raise the EJECT button
EJECT button
Insert the card
with the label
facing up.
(3) Push the EJECT button in to remove the card
Notes:
– 17 –
• When a P2 card is removed while the thumbnail
screen is displayed, the thumbnail screen is
automatically exited.
• Do not remove a P2 card while it is being
accessed or while it is being recognized after it
has been inserted (while its corresponding
access LED is flashing orange). If a P2 card has
been removed while it was being accessed, the
"TURN POWER OFF" display will appear on the
LCD monitor, and the "AUTO OFF" warning will
appear on the display panel. Also, all the P2
card access LEDs will flash rapidly in orange.
Turn off the power, and then turn it back on.
• The data contained on a P2 card which has
been removed while it was being accessed will
not be destroyed, but the clips may become
irregular. Check the clips first, and then fix them
if necessary. (See page 26)
• If a P2 card has been removed while it was
being formatted, no guarantees are made for its
formatting. Turn on the power, and format the
card again.