Sco - Moxa Technologies PCI Express Board User Manual

PCI Express Boards

SCO

• SCO OpenServer 5
• SCO OpenServer 6
• SCO UnixWare 7
Follow the steps given in this section to install the SCO OpenServer 5/6 & SCO UnixWare 7 driver. The
installation procedures for SCO UnixWare 7 and SCO OpenServer 5/6 are similar.
Copy the driver file .tar to your host.
1.
2. #tar xvf <driver tar file>
#/tmp/moxa/mxinstall
3. The window shown below will open next. Press RETURN to continue.
=============================================================
Copyright© 2008 Moxa Inc.
All Rights Reserved.
Moxa Smartio/Industio Family Device Driver Installation (Ver. 1.11)
=============================================================
For SCO UnixWare 7
Tar files, please wait.....O.K.
Press RETURN to continue
NOTE If your environment is SCO OpenServer 5/6, you can skip steps 4 and 5.
4. When you see the screen below, select "Esc" to exit and reboot your computer.
Board No.
1
2
3
4
5. After rebooting the computer, type "moxaadm"; when you see MAIN MENU, select Basic Configuration.
MAIN MENU
Basic Configuration
Advanced Configuration
Interface Configuration
Port Monitoring
Terminal Emulation
Driver Removal
Exit
MOXA Smartio/Industio Family Installation Utility (Ver 1.11)
Smartio/Industio Family Basic Configuration
Board Type I/O Address
None ------------
None ------------
None ------------
None ------------
PgDn: getty Setting
Enter: Confirm Input Value
Interrupt
------------
------------
------------
------------
Esc: Exit
Tab: Change Item
3-53
Software Installation
Bus/Dev No.
------------
------------
------------
------------