Output Signals On Voltage-Free Contacts; Programmable Input Free Contacts - GE Digital Energy SitePro 400 VAC CESeries 7 Operating Manual

9.1.3 Output signals on voltage-free contacts

The interface board provides 6 voltage free relay contacts giving some UPS critical alarms and
operation mode.
These signals are available either on connector J2- (sub D, female 25 pin) or terminal blocks X1.
The meaning of the alarms on the free contacts in standard configuration (default) is the following:
X1 / 1, 2, 3
X1 / 4, 5, 6
X1 / 7, 8, 9
X1 / 12, 13, 14
X1 / 15, 16, 17
X1 / 18, 19, 20
In case different alarms or operating status are required, they can be configured on the same terminals
via software from the control panel.
The configuration can be changed in parameters mode by a trained operator using the appropriate
password.
NOTE !
The programmable signals on X1 and J2 will be disabled with Q1 open, with the
exception of the signals for "16 - Manual Bypass ON" and "26 - EPO".

9.1.4 Programmable input free contacts

Some programmable UPS functions (indicated in Section 9.1), can be activated by closing an external
contact, if connected, on:
X1 / 10, 21 or
X1 / 11, 22 or
Modifications reserved
OPM_SPE_XXX_60K_60K_7GB_V010.doc
or J2 / 1, 2, 3
or J2 / 4, 5, 6
or J2 / 7, 8, 9
or J2 / 14, 15, 16
or J2 / 17, 18, 19
or J2 / 20, 21, 22
J2 / 10, 23
J2 / 11, 24
(NO, C, NC)
(NO, C, NC)
(NO, C, NC)
(NO, C, NC)
(NO, C, NC)
(NO, C, NC)
User Input 1 (default = Not used)
User Input 2 (default = Emergency GEN ON)
Mains Failure
Load on Inverter
Stop Operations
Load on Mains
General Alarm
Acoustic Alarm
Pagina 78/90
Operatine Manual SitePro 60 kVA