Serial Port J3 - Rs232 (Sub D, Female 9 Pin); Serial Port J11 - Rs232 (Sub D, Female 9 Pin) - Option - GE Digital Energy SitePro 400 VAC CESeries 7 Operating Manual

9.1.1 Serial Port J3 - RS232 (sub D, female 9 pin)

J3
Fig. 9.1.1-1 Serial port J3
The serial port J3 - RS232 is enabled on all the
units of the parallel system.

9.1.2 Serial Port J11 - RS232 (sub D, female 9 pin) - Option

J11
Fig. 9.1.2-1 Serial port J11
Connection of a serial printer
From the display panel it is possible to select
printing of measurements, alarms and parameters
(see Section 7.5 - User Parameters).
The serial port J11 - RS232 is enabled only one unit of the parallel system
(normally unit no. 1).
Do not use the serial port J11 on the other units of the same parallel system.
NOTE !
Communication on J11 port is enabled also in case the J3 connector is already connected.
Modifications reserved
OPM_SPE_XXX_60K_60K_7GB_V010.doc
Total remote management of the system using new generation
software JUMP (Java Universal Management Platform) for system
protection and management of systems using GE UPS.
JUMP system is written in JAVA and supports virtually all platforms
having "JAVA runtime environment".
Total remote management of the system on PC by means of the
ARGUS - Control Network Software (optional).
This software enables the user to monitor the status of remote UPS
Q4
from any computer connected to a modem, or through a direct link to
Q1
Q2
the UPS.
Fig. 9.1.1-1 Serial port J3 connection to PC
cable DB9m – DB9f
Fig. 9.1.2-2 Serial port J11 connection to PC with RS232
1:1 cable DB9m – DB9f
with RS232 1:1
Pagina 77/90
Operatine Manual SitePro 60 kVA