Hst (Hydrostatic Transmission) Fluid - CanyCom CMX222 Operator's Manual

HST (Hydrostatic Transmission) Fluid

NOTE
• To obtain correct reading, check HST fluid level before starting, or wait until HST
fluid cools off sufficiently. Hot HST fluid expands in volume and does not provide
correct reading.
• Always check oil level on a level surface.
• Oil to Use: Page 43.
• Oil Capacity: Page 43.
5321M-0508-060E
5321M-0508-070E
5321M-0508-060E
Maintenance
Inspecting
1.
2.
3.
Filler Cap
4.
5.
6.
7.
Upper Limit
8.
9.
Lower Limit
Filling
1.
2.
3.
4.
Filler Cap
5.
6.
Park machine on level ground.
Open engine hood.
Remove HST fluid filler cap and wipe its
dipstick clean.
Put filler cap back and fully screw it back.
Remove filler cap again.
Visually inspect fluid level. Make sure fluid
level is between upper and lower limits. If it is
below lower limit, add fluid.
Visually inspect condition of fluid. If it is too
dirty or viscosity is not normal, change fluid.
Put filler cap back in place and screw it
securely.
Close engine hood.
Open engine hood.
Remove HST fluid filler cap.
Fill HST fluid into filler.
Check fluid level.
Put filler cap back in place and screw it
securely.
Close engine hood.
-59-
5