Table of Contents
Advertisement
installation
16 |
CONTEMPORARY FACEPLATE INSTALLATION
CONTEMPORARY FACEPLATE INSTALLATION
Remove unit door prior to installation of faceplate.
Remove all contents from the package and lay out.
NOTE: Bolts may be pre-installed on unit and will need to be removed
prior to each step of the noted instructions. As a result, there may be
spare bolts.
1. Install tool and handle holder to the left side of the unit with on - 7/16"
bolt as shown below. (Note: part is packed with the manual package).
2. Install the upper left and right brackets using the four 7/16" bolts.
3. Install the left and right of the fascia panels using four 7/16'' bolts.
Fascia side panels installed with Bolts
CI2600/HI400 | wood insert
919-321
Handle / Tool holder
Brackets with Bolts
4. Attach the left and right side rails to the back of the bottom fascia panel
using four 7/16'' bolts, push each rail upwards before tightening.
NOTE: Wheels should be facing outward when completed.
Rail system secured with 4 bolts
NOTE: Fan cassette must be installed prior to this step. See fan install
instructions.
5. Remove the ring on the bypass rod by turning counter clockwise and
pull bypass rod forward to the open position. Then take the top fascia
panel and gently slide the bypass rod through the hole in the fascia
panel. Lift the fascia panel up slightly - push back to engage the brack-
ets installed on step 1.
Remove Ring from Bypass Rod
Back view of Top Fascia Panel lining up with the
brackets installed in Step 1
1
CI2600
04/15/14
Hide quick links:
Advertisement
Table of Contents
