Table of Contents
Advertisement
installation
24 |
OPTIONAL FAN/BLOWER INSTALLATION
OPTIONAL FAN/BLOWER INSTALLATION
Installer: Please record unit serial number here before installing blower—serial number will not be visible after blower
is installed.
______________________________
Serial No.
The fan should only be installed once the unit is in
place in order to prevent any damage to the fan.
1. Remove 2- 5/16" screws from locations
shown below—set aside for installation.
Remove 2 screws from locations shown
2. Slide the fan cassette fully into position.
Line up fan cassette with screw holes.
3. Align screw holes on fan harness bracket
with holes in fan cassette mounting bracket
on right and left sides.
CI2600/HI400 | wood insert
919-320a
4. Secure using the two (2) 5/16" screws re-
moved from Step 1.
Secure fan with 2 screws removed in Step 1
5. Remove 7/16" bolts from position shown
below.
**See specifi c faceplate installation instructions
for detailed instructions of fan switch assembly.
6. Align preset strain relief bracket to bottom
right corner of the faceplate, secure with 7/16"
bolt removed in Step 5.
Secure preset strain relief
7. Remove the dummy plug from the faceplate
being installed, by removing the 2 screws
along with washers and nuts. Discard dummy
plug, but keep hardware. Install fan switch
assembly with 2 screws, or use washers
and nuts for Cast Faceplate to lower fas-
cia before sliding faceplate into position.
Fan switch assembly
1
8. Tuck Power Cord to the bottom right hand side
of the faceplate as shown.
Tuck cord to right side of faceplate
Do not turn fan ON until your insert has reached
operating temperature or at least 30 minutes
after starting fi re.
CI2600
04/1514
Hide quick links:
Advertisement
Table of Contents
