Table of Contents
Advertisement
installation
10 |
INSTALLING YOUR INSERT
Your insert is very heavy and will require two or three people to move it into position. The insert can be made lighter by removing the cast iron
door by opening it and lifting it off its hinges. Be sure to protect your hearth extension with a heavy blanket or carpet scrap during the installation.
Evaluate your minimum cavity opening. If the cavity height lends itself to conduct the install without removing the flue collar, then just slide the unit into place
and position the liner within the flue collar and secure.
If the cavity dictates the flue collar needs to be removed or the optional offset flue adaptor is required, please follow the steps below.
1. Remove door, manual package, and bricks - see instructions in manual.
2. Remove Bypass Rod - turn counter clockwise.
3. The Bypass Rod was threaded through a "Fork" - access Fork through
the flue and remove by bringing it through the front of the unit.
Remove Fork
4. From inside the firebox - remove 7/16" bolt at back of firebox to remove
the flue collar.
CI2600/HI400 | wood insert
Bypass Rod
5. Install chimney liner, attach connector from flex kit with band and screws
(ensure tabs on connector are positioned so they won't get in the way
of the Bypass Rod - or remove them) attach flue collar with 2 or more
screws, to the liner within fireplace cavity.
Ensure to position at the proper height and angle to be able to attach the
unit.
6. Before sliding the unit into place and attaching the collar - the following
parts must be removed to allow access and a positive connection.
a)
Primary Air Shield
b)
Combustor Flame Shield
c)
Combustor
d)
Upper Shield - accessed through combustor opening
A -Primary Air Shield - loosen 2 x 7/16"
bolts - slide forward to remove.
B- Combustor Flame Shield - loosen 2 x 7/16"
bolts to remove.
Hide quick links:
Advertisement
Table of Contents
