Operator Interface - Terex DTM 00101 (standard) Operation And Maintenance Manual

4 MACHINE DESCRIPTION / CONTROLS

4.10 Operator Interface

The operator interface allows the operator to monitor machine systems and
configure the machine as needed to adapt to operator experience and conditions.
Note: to view the selection bar (if available) at the bottom of each screen, press
any of the four buttons beneath the screen.
Gauge Screen 1
When the key is turned to the on position, the operator interface powers up to
display gauge screen #1 (following two splash screens) as pictured below.
1400
0
800
This screen displays engine RPM, fuel level and battery charge in volts.
The selection bar visible on this screen allows the operator to:
• Access the brightness / contrast adjustment screen.
• Access the "status" menu (S).
• Access the "config" menu (C).
• Access the subsequent gauge screens (right arrow)
To access these sub menus, press the button below the desired icon.
1400
0
800
Engine
Once the temporary selection bar times out, the screen should look similar to this.
8
RPM
S
8
RPM
Fuel
12 16
C
Fuel
12 16
Vdc
46