Before You Start - Rinnai RF1800 Operation & Installation Manual

BEFORE YOU START

INSTALLATION REQUIREMENTS
This appliance MUST BE installed by an authorised person.
The installation MUST conform to local regulations.
The installation MUST also comply with the instructions supplied by Rinnai.
Service and removal MUST BE carried out by an authorised person.
CERTIFICATION
The Rinnai RF1800 has been certified by the Australian Gas Association.
The Certification Number is shown on the appliance dataplate.
No parts or functions are to be modified or permanently removed from the heater.
Please keep these instructions in a safe place for future reference.
CARTON CONTENTS
The main RF1800 engine components are supplied in a crate, components for additional installation methods are
packed separately. The following table lists the contents for each component package, ensure that the components
listed for the installation method being installed are present before proceeding with the installation.
A
2
3
Item
Rinnai RF1800 gas fire engine
1
Gas connection kit: 200mm 3/8 Flexi tube with plug and 3/8" - 1/2" reducing flare connector
2
Burner end cap
3
This Operation and Installation Manual
4
Rear reflector option for corner or fully recessed installation
5
Instructions for reflector panel installation
6
Rivet pack
7
End reflector option for through wall or fully recessed installation
8
Instructions for reflector panel installation
9
Rivet pack
10
Rinnai
4
1
Description
2
7
6
10
9
B
5
8
C
Contents
A B C
●
●
●
●
●
●
●
●
●
●
RF1800 OIM