Table of Contents
Advertisement
SECTION 7
PLUMBING SYSTEMS
WATER PUMP
Pressure for the water system is supplied by a
water system demand pump which is fully auto-
matic after initial priming. When a faucet is
opened, the pump begins operation to provide a
constant flow from the tank. When the faucet is
closed, the pump automatically shuts off.
Water Pump
Pump Strainer Filter
The pump is equipped with a cleanable strain-
er filter to capture any possible tank borne parti-
cles that could damage pump components.
NOTE: We recommend that you check and clean
this filter after each tankful of water dur-
ing the first frew uses of the water pump
system. Thereafter, remember to check it
at least yearly, such as during winteriza-
tion procedures.
7-2
Press cover in firmly and twist
counter-clockwise to remove
Water Pump Strainer
To Clean Pump Strainer
•
Push the flat inlet cover in towards the
rounded bowl section and twist counter-
clockwise about 1/4 turn to disengage from
locking tabs.
•
Remove the cap, then pull the strainer out of
the bowl. Tap out any particles and rinse
clean.
•
Insert the strainer back into the bowl, then
twist the cap back into the bowl assembly to
close.
Water Pump Switch
Your coach is equipped with water pump
switches in three convenient locations:
•
on the monitor panel (see section 8)
•
in the utility service compartment on the out-
side of the coach
While any pump switch is in the "ON" posi-
tion, the pump will automatically supply water
pressure as it is needed. It is recommended that
the pump switch be turned off whenever you are
away from the vehicle or not using the water sys-
tem. A slow leak in a faucet could drain the water
system and discharge the coach battery.
Advertisement
Table of Contents
