Table of Contents
Advertisement
SECTION 10
STORING YOUR MOTOR HOME
2-6 above) to remove and rinse the RV
antifreeze from the machine.
Dishwashing Winterizing
1. Empty all dishes from the dishwasher.
2. Follow coach winterization instructions for
using the winterization valve to draw RV
water system antifreeze into the water sys-
tem so antifreeze can enter the dishwasher.
3. Set the dishwasher controls to the start of the
Rinse cycle and run briefly until antifreeze
can be seen inside the dishwasher.
4. Set the controls to the end of the Rinse cycle
to pump the liquid out of the dishwasher to
make sure the lines and pump contain anti-
freeze.
5. Turn dishwasher controls to Off.
6. Pour about a quart of RV water system anti-
freeze directly into the dishwasher to ensure
protection of pump and drain lines.
7. Dishwasher is now winterized.
To Winterize the Fresh Water Hose
Reel:
The recommended method to winterize the
hose reel is to use compressed air (limited to 30
psi or less) to blow out the hose and line. Open a
faucet inside the coach, then insert an air nozzle
into the end of the hose and force out the remain-
ing water from the hose and reel line. A one-way
check valve will keep water in the coach water
lines from re-entering the hose if you still wish
to use the water system from the fresh water tank
without city water hookup.
REMOVAL FROM
STORAGE
1. Completely air out the motor home.
2. Have the entire LP gas system checked for
leaks.
3. Check window operation.
4. Check cabinet and door hinges. Lubricate
with penetrating oil, if necessary.
5. Close all faucets and drain valves that are
open. If necessary, reconnect toilet water line
and close flush valve.
10-6
6. Add a few gallons of water to the fresh water
tank and check for leaks especially at junc-
tions. Also make sure all hangers and sup-
ports are securely in place. Sanitize the water
system as outlined under "Disinfecting the
Fresh Water System" in Section 7.
7. Check operation of all faucets to be sure fau-
cet washers have not hardened during stor-
age.
8. Check sealing valve in the toilet for proper
operation and lubricate with silicone spray.
9. Add water to the holding tank using the toilet
flush pedal. Check to be sure dump valve
seals tightly.
10. Check around all appliances for obstructions
and ensure that all vent openings are clear.
11. Start refrigerator and check for proper cool-
ing.
12. Clean paneling and counter surfaces and
apply a thin coat of wax.
13. Replace batteries if necessary and check out
electrical system to make sure all lights and
electrical components operate.
14. Check tires for proper cold inflation pres-
sure.
15. After washing accumulated winter grime
from the vehicle, it is important to carefully
inspect the seams and sealants for separation
or cracks that may have appeared around the
window frames, vents and any other joints.
Re-sealing is quite simple and the material is
quickly and easily applied. Appropriate com-
pounds are available from your dealer. Also
inspect weather seals around doors, etc., and
if necessary, have a dealer replace immedi-
ately.
Advertisement
Table of Contents
