Table of Contents
Advertisement
To extend generator frame for service:
1. Pull the travel-locking pin from the slide rail.
It is located on the driver side of the genera-
tor and can be seen by looking down just
inside of the "hood" panel opening as indi-
cated by the arrow in the photo below. The
pin is tethered to the rail assembly by a small
cable.
Travel Pin - see arrow
Viewed looking downward at left side of generator
through front "hood" panel opening.
2. Push the power slide switch downward and
hold until generator frame is fully extended.
Lift the switch upward and hold to retract the
generator.
ELECTRICAL SYSTEMS
Press switch down to extend; up to retract.
3. After retracting the generator, be sure to
reinsert the travel pin into the slide rail
frame. You may need to move the generator
and grille panel in or out slightly by hand to
align the holes properly to insert the pin.
CAUTION
Make sure travel pin is in place to
secure generator before driving after
generator service or maintenance.
Failure to do so may allow the gener-
ator to extend unexpectedly during
sudden brake application or other
rapid deceleration.
SECTION 6
6-9
Advertisement
Table of Contents
