Table of Contents
Advertisement
SECTION 2
DRIVING YOUR MOTOR HOME
Crank the tire winch clockwise slowly, until
the room is fully retracted. Allow about 10
minutes to crank room in fully.
NOTE: Attempting to crank the room in too
quickly will raise pressure in the hydrau-
lic fluid lines and make cranking more
difficult.
Step 3 - Secure Travel Straps and Close
Hydraulic Line Valves
• Fasten the slideout room Travel Straps.
• Close the hydraulic pump solenoid valves
completely.
NOTE: Close the valves snugly, but do not over-
tighten. Overtightening may cause inter-
nal damage to the valves.
• See your dealer for service of the room exten-
sion system before using again.
Bedroom Slideout Emergency 'Push-
In' Procedure
•
Open the "slideout" hydraulic line valves on
the pump to relieve hydraulic line pressure.
(See Step 1 under "Slide-Out Room Emer-
gency Crank-In" on previous page.)
•
DO NOT OPEN THE LEVELING JACK
VALVES.
•
Apply a steady inward pressure of approxi-
mately 150 lbs. to the exterior sidewall of the
slideout room to push the room in toward the
coach until it is snug against the main coach
sidewall.
2-30
•
NOTE: Use some type of rigid, padded mate-
rial to protect the sidewall from punctures,
dents or other damage to the finish from any
device or equipment used to press the side-
wall in.
•
Pressure must be applied evenly to avoid
binding of the hydraulic mechanism. It may
take about 10 minutes to press the room
extension inward completely.
•
When the room is snug against the coach
wall, close the solenoid valves to prevent
"creep out" during transit.
•
See an authorized Winnebago Industries
dealer for service of the slideout control sys-
tem.
See your Authorized Winnebago Industries
Dealer for service of the slideout system before
using again.
NOTE: When the system has been corrected,
check hydraulic fluid level and refill res-
ervoir as necessary. Press the Retract
switch for 15 to 20 seconds before at-
tempting to extend the room. Then run
the room out and in several times to
purge any air from the hydraulic system.
Finally, recheck fluid level and fill as
necessary.
Further Information
See the HWH Hydraulic Room Extension
operating guide included in your Owner's Info-
Case for further instructions and troubleshooting
information.
Power Awnings
The awning control switches are on the entry
switch panel.
Advertisement
Table of Contents
