Table of Contents
Advertisement
WARNING
Do not operate the cruise control on
icy or extremely wet roads, winding
roads, in heavy traffic, or in any other
traffic situation where a constant
speed cannot be maintained.
WIPER FUNCTIONS:
There are four wiper control buttons:
•
ON/HI/LO
•
DELAY
•
WASH/WIPE
•
OFF
WASH/WIPE
•
Press switch to activate Lo wipers and spray
washer fluid onto the windshield for as long
as you hold the button.
•
After you release the button, the wipers will
continue for three wipe cycles, then turn off.
•
If wipers are already active, pressing the
switch will simply spray fluid onto the wind-
shield without affecting wiper setting.
WIPER ON/HI/LO
•
Press to turn wipers on at Lo speed
•
then press again to switch wiper speed back
and forth from Lo to Hi speed.
•
Press Off button to switch wipers off.
DRIVING YOUR MOTOR HOME
WIPER DELAY
This switch will set a Lo speed wiper delay time
based on the duration between any two presses
of the button.
Here's how it works:
•
During a light rain or mist, when your wind-
shield needs a clearing wipe, press the button
once and the wiper will swipe back and forth
once a Lo speed. Let's say 7 seconds later,
the windshield needs another wipe - press
the button again and the delay time will be
set to 7 seconds.
•
If the mist gets heavier and you press the
button again 3 seconds after the last wipe,
the delay time will be reset to 3 seconds.
•
The delay time can be set from approxi-
mately 1 to 30 seconds.
WIPER OFF
•
Press to shut wipers off.
•
Wipers will also switch off whent he ignition
is turned off.
NOTE: Many states now have laws that require
headlights to be on during precipitation
conditions. To assure compliance with
this law, the headlights will come on
whenever you press any of the wiper
function buttons - Hi/Lo, Wash or Delay.
You can manually reset the headlights by
the cycling the headlight switch (on the
dash) on and off. The headlights will also
turn off when the ignition switch is
turned off.
IDLE SPEED CONTROL
The cruise control system can also be used to
increase or decrease engine idle speed (rpm)
while parked if desired. Press the ON/OFF button
to activate or deactivate the idle control circuit.
Press the Brake Pedal to cancel idle speed func-
tions and return to normal idle.
SET BUTTON INCREASES IDLE RPM
FROM NORMAL IDLE SPEED:
•
Press and release to increase engine speed
from normal idle to about 1000 rpm.
SECTION 2
2-7
Advertisement
Table of Contents
