Winnebago 2004 Ultimate Freedom Owner's Manual page 104

SECTION 8
APPLIANCES & INTERIOR FEATURES
Generator Start/Stop Switch
See Section 6, Electrical Systems for genera-
tor start-up and shut-down instructions.
Generator Hourmeter
See Section 6, Electrical Systems for genera-
tor hourmeter information.
Water and Holding Tank Levels
Press and hold the "Levels Test" switch to
show approximate level on the monitor lights.
The approximate water levels are measured by
sets of electronic probes in the sides of the tanks,
so the water must be touching a probe to register
at that level. There is generally more water in a
tank than indicated on the monitor panel.
For example, a water level of 1-2" below the
FULL probe, the monitor will show the level to
be only 2/3 even though the tank is nearly full. If
the water level is below the 1/3 probe, the moni-
tor will register an empty tank because the water
is no longer touching the 1/3 probe. There may
actually be some water left in the tank. However,
when the indicator reads FULL, the tank is actu-
ally full.
8-8
Generator Switch
and Hourmeter
Tank Capacities
See back of "To The Owner" page inside
front cover of this manual.
LP Gas Level
Press and hold the "Levels Test" switch to
show approximate LP tank level.
The LP level is registered by a sending unit on
the tank. The gauge mounted on the side of the
tank will give a more accurate indication of actu-
al tank level if needed.
Water Pump Switch
When you want to use the self-contained
water system, turn on the "Water Pump" switch
on the monitor panel. The "Pump On" light will
illuminate when the pump switch is turned on.
Water will be available as soon as a faucet is
opened.
For your convenience, additional switches are
located in the bathroom and in the water center
compartment.