Table of Contents
Advertisement
SECTION 8
APPLIANCES & INTERIOR FEATURES
NOTE: The thermostat does not automatically
switch between heating and cooling. You
must place the switch in the desired posi-
tion.
Heating:
•
Slide the thermostat switch to "Heat" posi-
tion.
NOTE: Follow proper hydronic heater start-up
procedures described previously in this
section.
NOTE: If your coach is equipped with the
optional electric Heat Pump, be sure the
Thermostat switch is in Gas Heat posi-
tion. See Heat Pump for details.
Heat Source Switch
ELECTRIC = Heat Pump
GAS = Furnace
•
Adjust the temperature setpoint to personal
preference if needed. See "Set Temperature"
8-14
Temp Selector
below.
Digital Thermostat Display
The digital display normally shows current
room temperature, with the word "ROOM" in
small letters at the left side of the display. When
you press the temperature selector button up or
down, the display will show the word "SET" and
the new temperature setpoint until you release
the button.
Set Temperature
To set the temperature to a new temperature,
simply press the Temperature Selector button up
or down until the temperature you want appears
in the display. The word "SET" will also appear
at the left side of the display while you are
changing the temperature setpoint. A few sec-
onds after you release the temperature selector
button, the display will return to showing the
current room temperature.
Cooling (A/C):
•
Slide the thermostat switch to Cool position.
•
Slide the Fan Mode and Fan Speed Switches
to the desired positions.
On/Low: A/C compressor cycles on and off
with the thermostat while fan runs continu-
ously at low speed.
On/High: A/C compressor cycles on and off
with the thermostat while fan runs continu-
ously at high speed.
Auto/Low: Fan runs at low speed and cycles
on and off with the A/C compressor as con-
trolled by the thermostat.
Auto/High: Fan runs at high speed and
cycles on and off with the A/C compressor
as controlled by the thermostat.
•
Adjust the temperature setpoint to personal
preference if needed. See "Changing Tem-
perature Setpoints".
To Run Fan Only (No Heat or Air)
•
Set Thermostat switch to OFF.
•
Slide Fan Mode switch to On.
•
Place Fan Speed switch to Lo or Hi as
desired
Advertisement
Table of Contents
