Table of Contents
Advertisement
Water Pump
Switch
Battery Condition Meter
Press and hold the switch to display condi-
tion of either House Battery or Engine Battery.
The LCD display will show the current battery
voltage to the nearest tenth of a volt.
•
A 12-volt battery typically registers any-
where from 12.5V to 13V when adequately
charged.
•
Voltage below 12.5V indicates a discharged
condition; 12V or less is effectively 'dead'.
•
Voltage above 13V typically indicates that
the battery is being charged by the inverter
charger system.
To get an accurate reading;
1. Both the chassis engine and the auxiliary
generator engine must be shut off.
2. An interior light should be turned on to pro-
vide a small load which draws off the battery
surface charge.
APPLIANCES & INTERIOR FEATURES
Dish Drawer Lock Feature
The Dish Drawer must be programmed to the
'Closed Drawer' option to keep the drawer
locked while driving. See the Dish Drawer User
Guide page 14 & 15 "Option adjustment mode"
Integrated version.
1. Press the power button (left side of touch
panel).
2. Open the drawer, then press the ECO button
on the inside of the drawer and the Lock but-
ton (right side of touch panel) at the same
time until you hear one long beep.
3. Press the start/pause button (center of touch
panel) 3 times; the light above the button
will be red.
4. Press the Lock button (right side of touch
panel) to turn the "Closed Drawer" feature
on. The lights on display panel inside of the
drawer will light up.
5. Press the power button (left on touch panel)
the unit is set.
SECTION 8
8-9
Advertisement
Table of Contents
