Table of Contents
Advertisement
TV ANTENNA
The TV antenna on your motor home can be
easily raised, rotated a full 360° and lowered
from inside the vehicle by simply turning a crank
or rotating knob. A built-in signal amplifier de-
signed to strengthen signals, is controlled by a
power switch built into the TV jack assembly.
The signal amplifier is housed inside the an-
tenna with the circuit board connected directly to
the antenna elements. Power to operate the am-
plifier (12-volt DC) is supplied through the
downlead cable which also carries the TV signals
to the TV set. The power supply separates the 12-
volt DC from the TV signals and provides a place
for attaching the TV set and the 12-volt power
source.
Operation
Raising Antenna - Turn elevating crank
clockwise in "UP" direction about 13 turns or
until some resistance to turning is noted. Antenna
is now in operating position. Turn amplifier pow-
er switch "ON" to receive TV signal.
WARNING
Never allow the antenna to touch
electrical power lines or any other
electrical wires.
Rotating Antenna - Make sure antenna is in
the "UP" position. Pull down on rotating knob
until it disengages ceiling plate and rotate for best
picture and sound on TV set.
APPLIANCES & INTERIOR FEATURES
Lowering Antenna to Travel Position -
Rotate antenna until pointer on rotating knob
aligns with pointer on ceiling plate.
Never leave the antenna partially
raised or partially lowered. This can
damage the crank mechanism gears.
Always raise the antenna straight up
or lower it completely into the travel
position.
Turn elevating crank (counterclockwise) in
"DOWN" direction until resistance is noted.
Antenna is now locked in travel position. Turn
amplifier power switch "OFF".
Count the number of turns needed to crank the
antenna down to the roof of the unit (normally
about 13). Mark the final position of the crank
handle on the ceiling or the directional knob for
reference. Also mark the number of turns needed.
Use the mark and number as a reference when-
ever you lower the antenna.
Always align directional handle to
"DOWN" position before lowering.
ANTENNA SIGNAL AMPLIFIER
The TV Signal Amplifier switch is located on
the left end of the Video Selector System panel as
shown. To operate amplifier, turn on power
switch.
SECTION 8
CAUTION
CAUTION
8-17
Advertisement
Table of Contents
