Section 17. Zone Lists; Menu Mode; In This Section - ADEMCO Vista-10SE Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

In This Section

About Zone List Menu Mode
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
About Zone List Menu Mode
Zone List Menu mode is used to program zone lists for output devices (programmed in 80
Menu mode). Refer to the Programming Form worksheet ( 81) that programs the Zone Lists
for Output Devices.
To program the zone lists, press 81 while in Program mode.
Zone List Displays
Zone List No.
(00 = Quit)
01 Enter Zn Num.
(00 = Quit)
01 Del Zn List?
0 = No 1 = Yes
01 Delete Zone?
0 = No 1 = Yes
01 Zn to Delete?
(00 = Quit)
Enter the Zone List Number 01, 02, or 03 you want to program (or
00 to end these entries). Press [ ] to advance.
01
In the following displays, zone list 01 has been selected for
programming.
Enter each zone number to add to the zone list by first entering the
zone number, then
00
desired are entered, press 00 to advance.
IMPORTANT: Do not include fire zones in zone lists that are used
to STOP relay actions.
To delete the zone list, enter 1 (Yes). All zones in the zone list are
deleted automatically, and programming returns to the first
0
screen.
To save the zone list, enter 0 (No) to advance.
To save the entire zone list, enter 0 (No). Programming returns to
the first screen.
0
To delete a zone or zones in a zone list, enter 1 (Yes) to advance.
Enter each zone to be deleted from the list, followed by . After all
zones to be deleted are entered, enter 00 to return to the first
00
screen so that another list can be programmed, if desired.
Any list may include any or all of the system's zone numbers except zone 08.
A zone list can be assigned to more than one output relay.
WWW.DIYALARMFORUM.COM
S E C T I O N
Zone List Displays
(for example, 01 , 02 , 03 ). After all zones
1 7
Zone Lists

( 81 Menu Mode)

17–1