Section 15. Zone Programming; About Zone Programming - ADEMCO Vista-10SE Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

About Zone Programming

56 Zone Programming Mode Procedures
58 Expert Programming Mode Procedures
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
About Zone Programming
56 Zone Programming and 58 Expert Programming are Interactive Menu modes that are
used to program zone numbers, alarm codes, and report codes, and to identify the type of
input device. These modes can also be used for "enrolling" 5800 Series RF Wireless
Transmitter serial and loop numbers. 56 Zone Programming can be used for entering alpha
descriptors for zones (we recommend entering descriptors in menu mode 82). Refer to the
zone assignment table for 56 and 58 on the separate Programming Form.
56 Zone Programming Mode Procedures
NOTE: Before proceeding, you must program field 22 (RF System) as required.
In the Programming mode, press 56.
SET TO CONFIRM?
0 = NO 1 = YES 0
Enter Zn Num.
(00 = Quit)
Zone 10 entered
ZN ZT RC
10 00
This display appears upon entry into 56 mode. The default is 0
(No). If you enter 1 (Yes), you are prompted to confirm each
transmitter after entering the serial and loop numbers (at the
XMIT TO CONFIRM prompt later in this procedure).
We recommend that you confirm the programming of every
transmitter.
Zone Number (Zn): Enter the zone number that you wish to
program.
10
Zone 10 has been entered as an example in display at left.
↑
Press [ ] to continue.
A summary display appears, showing the status of that zone's
IN: L
programming when using wireless keys.
10 RF: –
NOTE: If you are programming hardwired zones 01-06, the
display appears as follows.
Press [ ] to continue.
WWW.DIYALARMFORUM.COM
Zone Programming
To Remove a Zone
To Delete a Transmitter Serial Number
To Enter and Duplicate Wireless Keys
Zn ZT RC In: L
02 00 10 HW: -
S E C T I O N
( 56/ 58 Menu Mode)
1 5
15–1