ADEMCO Vista-10SE Installation And Setup Manual page 29

1. Wire the VIP Module exactly as shown, using a direct-connect cord and RJ31X jack.
2. If you do no hear tones when pressing keys after accessing the security system via an on-premises
phone, try reversing the pair of wires connected to terminals 3 and 4 on the VIP Module and the
pair of wires connected to terminals 17 and 18 on the control.
3. If you hear an error signal (fast busy signal) when trying to access the system via the phone, check
for correct line seizure wiring, as described in note 4.
4. Connection to the incoming telco line via a RJ31X jack and direct-connect cord, as shown in this
diagram, is essential, even if the system is not connected to a central station. The 4285 or 4286
will not function if this is not done.
The house phone lines (gray and brown wires) must be wired to the VIP Module
terminals, not to the control terminals. Otherwise, an error signal (fast busy signal) will
occur when you try to access the system from an on-premises phone.
5. If the telephone system on the premises includes a Caller ID unit, connect the unit directly to the
"Handset" terminals (17 and 18) on the control, as shown.
TERMINALS
ON CONTROL
CALLER ID
UNIT
IMPORTANT NOTE FOR
EXISTING INSTALLATIONS:
EXISTING WIRES
CONNECTED TO THE
"HANDSET" TERMINALS ON
CONTROL MUST BE MOVED
FROM THERE TO TERMINALS
3 AND 4 ON THE 4285.
4285/4286
V IP MODULE
SPEAKER VOLUME
ADJUSTABLE ON
4286 ONLY
KEYED
HEADER
YELLOW: TO DATA OUT (term. 7)
UNUSED
NO CONNECTION
CONNECTOR RED:
BLACK:
WITH FLYING
GREEN:
LEADS
Figure 11. 4285/4286 VIP Module Wiring Connections
WWW.DIYALARMFORUM.COM
4285/4286 VIP Module WIRING NOTES:
Incoming
Handset
Teleco Line
17
18 19 20
DIRECT
CONNECT
CORD
TO AUX (+) (term. 5)
TO AUX. GROUND (–) (term.4)
TO DATA IN (term. 6)
Section 7 - 4285/4286 VIP Module
TO EARTH GROUND (COLD WATER PIPE, ETC.)
21
INCOMING TELCO LINE
TIP
RJ31X
RING
JACK
CA38A
IN
PLUG
CANADA
NO
CONNECTION
*
NOTE: IF THE TELEPHONE HAS BUILT-IN CALLER ID,
THE CALLER ID FUNCTION MAY NOT WORK .
TO CONTROL
PANEL
TERMINAL ASSIGNMENTS
TERMINALS
1 - TIP
USED FOR
2 - RING
KEYPAD
3 - TIP
CONNECTIONS
4 - RING
5 - NO CONNECTION
6 - }
AUDIO OUT
7 - 4286 ONLY
PREMISES ANSWERING
MACHINE AND PHONES
ANSWERING
MACHINE
*
*
4285/4286
}
PHONE INPUT
}
PHONE OUTPUT
V10SE-029-V0
7-3