ADEMCO Vista-10SE Installation And Setup Manual page 76

VISTA-10SE Installation and Setup Guide
P r o g r a m A l p h a ?
0 = N o , 1 = Y e s
C u s t o m W o r d s ?
0 = N o , 1 = Y e s
Default Descriptor ↓
Z N 0 1
Flashing Cursor (system is
ready for entry of word).
Z N 0 1
Flashing Cursor
Z N 0 1
Z N 0 1
↑
Flashing Cursor if [6] is
pressed (system is
ready for next word).
Z N 0 1
D O O R
↑
Flashing Cursor
18-2
2. Enter 82. The "Program Alpha ?" prompt appears.
If you press 0 (No), proceed to step 4.
0
3. By pressing 1 (Yes) in step 2 above:
The "Custom Words ?" prompt appears. Proceed to the six
0
steps for Adding Custom Words later in this section.
4. By pressing 0 (No) in step 2: The system then
automatically displays the default descriptor for zone 01.
If a descriptor was not entered previously for zone 01, the
default descriptor for zone 01 will be displayed.
Z O N E 0 1
Note that no entries can be made. Entries can be made only
when the display contains a flashing cursor, which signifies
the "entry mode."
5. To delete or change the default descriptor for zone 1,
press [
↓
clear that descriptor and gain access to the entry mode
with flashing cursor, allowing changes to be made.
A
NOTE: If you do not wish to change the existing descriptor
for zone 01, enter [
you wish to enter (or check) a descriptor. A summary
display for that zone will appear. You must then press [
plus the same zone number again to gain access to the
entry mode (flashing cursor) for that zone.
↓
6. Press [#] plus a 3-digit number for the first word from
the ALPHA VOCABULARY LIST on a following page.
B A C K
Example: The descriptor that we wish to enter for zone 01
is BACK DOOR. From the LIST, BACK = 013.
Therefore, we enter # 0 1 3.
NOTE: If you accidentally enter the wrong word, simply
press [#] plus the correct 3-digit number for the word you
want.
7. Press [6] to accept the selected word and continue.
B A C K
NOTE: If this is the only word you are using for the
descriptor, press [8] instead of [6] to save that word in
memory, and then go to step 11.
8. Enter the 3-digit number for the next word. In our
B A C K
example, the word is DOOR, whose number is "057."
Enter # 0 5 7. This display will appear:
WWW.DIYALARMFORUM.COM
] plus the same zone number (01). This will
plus the next zone number for which
]
]