ADEMCO Vista-10SE Installation And Setup Manual page 49

DIALER
PROGRAMMING
( 40– 50)
Fields 40, 41, 42:
Enter up to the number of
digits shown. Do not fill
unused spaces.
Enter 0–9,
# + 11 for
# + 12 for #
# + 13 for a pause
(2.5 secs)
39 AUDIBLE EXIT WARNING
If enabled, this field provides exit warning sound when armed AWAY
or MAXIMUM.
Warning sound consists of slow continuous beeps until last 5 seconds,
when it changes to fast beeps. The warning sound will end at the
termination of Exit time.
0 = no; 1 = yes.
40 PABX ACCESS CODE (See box at left.)
Enter up to 4 digits if PABX is needed to access an outside line. If
fewer than 4 digits are needed to be entered, exit by pressing
next field number (e.g., 41). To clear entries from field, press 40 .
41 PRIMARY PHONE NO. (See box at left.)
Enter up to 12 digits.
pressing
field, enter 41 .
NOTE: Backup reporting (8 calls are made to the secondary phone
number if no kiss-off is received after 8 attempts to primary
number) is automatic only if there is a secondary phone number
(field 42).
42 SECONDARY PHONE NO. (See box at left.)
Enter up to 12 digits.
pressing
field, enter 42 . See NOTE in field 41 also.
NOTE: If you wish to send a report to a pager, see field 47
on a following page .
43 SUBSCRIBER ACCOUNT NO.
Enter digits 0–9, #+11=B, #+12=C, #+13=D, #+14=E, or #+15=F.
Enter as the fourth digit if a 3-digit account no. (for 3+1 dialer
reporting format) is used.
account no. for nos. 0000–0999. End field by pressing
next field) if only 3 digits are used.
This field is also used as the Long-Range Radio Subscriber Account
No.
45 PHONE SYSTEM SELECT
If central station receiver is not on WATS line:
0 = Pulse Dial;
1 = Tone Dial
If central station receiver is on WATS line:
2 = Pulse Dial
3 = Tone Dial
WWW.DIYALARMFORUM.COM
If fewer than 12 digits entered, exit by
and next field number (e.g., 42). To clear entries from
If fewer than 12 digits entered, exit by
and next field number (e.g., 43). To clear entries from
Enter 0 as the first digit of a 4-digit
Section 14 – Data Field Descriptions
(1-Digit Entry)
(Enter up to 4 digits)
(1-Digit Entry)
nd
(and press
14-3