Note:
The printer supports a baud rate up to 115200. Make sure your host
is capable of communicating at the speed you select for the printer.
U s i n g t h e C o n t r o l P a n e l
The control panel has a two-line LCD display, 2 status lights, and five
buttons. The control panel displays error codes/messages, and allows you
to setup/configure the printer.
Printer Status Lights
Power:
The printer shows a steady green light
when it is on.
The Power light blinks when the battery
needs to be recharged (only on
battery-powered/cart models).
Fault:
The printer shows a blinking amber
light when there is a printer error.
Button Functions
Feed/Cut:
1-6 Operator's Handbook
♦
Prints a label in the on-demand mode.
♦
When the printer is online, feeds a blank label if there is
no print job.
♦
Prints a label with error information that is useful to your
System Administrator if an error is displayed.
♦
When the printer is online, cuts the supply when pressed
and held for two seconds if a knife is installed.
♦
When the printer is offline, changes the displayed value
by one or 10.