Avery Dennison TrafficJet Instructions Manual

Avery Dennison​
TrafficJet​ ™ ​ - New Facility Move Instructions
Instructional Bulletin : # 9.44
Revision : # 01
Last Updated : Nov 2019

Procedure for moving the Trafficjet to a new facility.

The below process is to be followed prior to moving the Trafficjet to the new facility.
This should only be performed with printers less than 12 months old and must be setup
within 10 days of shipping to avoid damage to the ink system.
Please consult with your Avery Dennison Specialist Team to confirm the printer is in a
shippable condition and any appropriate parts are replaced before the following
procedure can take place.
Note: Before proceeding please ensure the appropriate packaging is ready to
allow for the printer to be packed up. This is the large pallet or crate the printer
came in. If you have disposed of the packaging please contact your local Avery
Dennison Team to arrange alternative packaging.
1.) Perform a Longstore. This will drain out all of the ink currently in the system and
then flush out and residual from the lines and sub tanks. Ensure you have 8 full flush
cartridges (or bags) to perform this process. Make a note of the location of each color
prior to starting this process. Please also ensure you have a fresh, full sealed set of
spare inks at the facility the printer is being shipped too.
To perform:
- Press Menu
- Select Setup
- Cycle Down to "Set 19: Longstore" and press enter.
- Follow the on-screen prompts and do not move to the next step until prompted.
Instructional Bulletin IB# 9.44
TrafficJet​ ™ ​ - New Facility Instructions
Page 1 of 6
reflectives.averydennison.com
Ⓡ