Trouble Shooting - Avery Dennison TTX 207 Manual

04/02 Rev. 2.15-01

Trouble shooting

TTX 207 – Da Capo
Errors during operation are indicated by means of the red LED at the opera-
tion panel.
By pressing the FEED key an error code may be called off via the yellow LED
in order to recogneize the kind of error.
After correction of the error the error indication has to be confirmed by pres-
sing the ON/OFF key. After switching the printer to ONLINE mode the job will
be continued. Partly printed labels will be repeated.
LED-Code Error
• • • – – Pressing lever open
– Material end
• • • •
• • • • • NOVRAM read error
– NOVRAM write error
• • • •
– No gap found on 3 or more
• • • •
labels
– – RS232 - Transmission Error Check adjustments: baud
• • •
• – • – • RS 232 - Reception Buffer
overflow
• – – – • RS232 - Reception error pa-
rity
– Memory Allocation Error
• • • •
• – • • – Font Allocation Error
• • – • – Unknown Interrupt
Tab. 1: Blink codes of the yellow LED (
MANUAL
•
= short lighting up, – = long lighting up).
Setup, Operation, Service, page 11
Measure
Close lever, punch is re-in-
itialized, job will be continu-
ed.
Insert material and check
position of gap sensor,
punch is re-initialized, job
will be continued.
Call service technician
Call service technician
1. Check gap definition in
printing mask.
2. Check whether correct
material is inserted.
3. Check whether light barri-
er is cleaned.
4. Check material guide and
position of light barrier.
rate, stop bits, no. of data
bits and correct them at
computer and/or printer if
neccessary. Check trans-
mitting line and external in-
fluences.
Check synchronisation of
data transmitting and cor-
rect it at computer and/or
printer if neccessary.
Check parity adjustment
and correct it at computer
and/or printer if neccessary.
Call service technician
Call service technician
Call service technician