Table of Contents
Advertisement
04/02 Rev. 2.15-01
General notes
TTX 207 – Da Capo
Before using the printer....
The following warning hints and precautions contained in these Operating In-
structions must be strictly observed. This will considerably contribute to the
safe and expert operation of your printer.
Exclusively original parts and accessories available from the manufacturer
are to be used in order to maintain the service life of your prlnter. The use of
parts not in compliance with the exacting demands made by the manufactu-
rer may result in unnecessary sources of troubles.
The housing of the unit must exclusively be opened by authorized technical
personnel only.
Insertion/Exchange material should be carrled out only by especially instruc-
ted personnel (Set Up Mode!).
On operation with open cover, fingers, hair, clothes, jewelry, etc. may be
caught by and get into the unit in the print modul.
At a material width less than 65 m the thrust screw has to be tightend.
Release printhead by opening the pressing lever during longer periods of no
operation.
Wait at least 10 seconds before switching unit back „ON".
Do not remove, insert or exchange PLUG IN CARDS until after at least 60
seconds from switching „OFF" the device.
Copyright
This User Manual and its contents are subject to copyright. The publisher's
prior written consent must be obtained for reproduction of the Manual as a
whole or part thereof.
Avery reserves the right to technical and other alterations without prior notice.
MANUAL
Setup, Operation, Service, page 2
Advertisement
Table of Contents
