Table of Contents
Advertisement
06/08 Rev. AA
Starting to print
Material type
Material length
Material width
Type of punch
4-inch width
(100 mm)
2-inch width
(50 mm)
QUICK REFERENCE
Settings for the material type
The parameter settings below describe setting up the label material.
When printing from a layout program, these settings are usually provided
automatically by the printer driver. For your first test prints, you need to
configure them manually.
The label material is endless (continuous) which means that it contains no
punches/perforations, breaks or reflex marks that could be recognized by the
punch (die cut) sensor:
Set the
PRINT PARAMETER > Material Type
The label material contains punches/perforations, breaks or reflex marks that
can be recognized by the punch sensor (so-called "punched" material):
Set the
PRINT PARAMETER > Material Type
Set the
PRINT PARAMETER > Material Length
Set the
PRINT PARAMETER > Material Width
Only for punched/perforated (die cut) material:
Label material with breaks or punches:
Set the
SYSTEM PARAMETER > Sensor Type
Label material with reflex marks:
Set the
SYSTEM PARAMETER > Sensor Type
For more information on setting parameters: refer to "Info-Printouts and
Parameters."
Printing the status report
To test the printer, print a status report. The width of the status printout can
be set to 4 inches (100 mm) or 2 inches (50 mm). This should match the width
of the label material used. The length of the printout is 8 inches (200 mm).
Navigate to
INFO PRINTOUT > Printer Status
The printout (two 8-inch labels) lists all of the printer's current parameter
settings.
Set the
SYSTEM PARAMETER > Print Info Mode
Navigate to
INFO PRINTOUT > Printer Status
This printout contains the same information as the 4-inch printout,
compressed to a 2-inch width.
9864
to endless.
to "Punched."
to the length of the material (in mm).
to the width of the material (in mm).
to Punched.
to Reflex.
.
to "Compact right."
.
15
Advertisement
Table of Contents
