Removing A Dummy Module - Fujitsu PRIMERGY RX600 S4 Operating Manual

Hot-plug components
8.1.5.2

Removing a dummy module

If a slot does not contain an expansion card, it is occupied by a dummy module.
This is a retaining plate with an attached removal tool.
Before inserting an additional hot-plug expansion card, you will first have to
remove the dummy module from its slot.
Ê Remove the housing cover (see
page 114).
Ê Remove the dummy module in the same way as a PCI board (see
on page 100).
Removing the retaining plate from the removal tool
Figure 34: Removing the retaining plate from the removal tool
V
CAUTION!
When removing the retraining plate from the removal tool, pay particular
attention to the engaging hooks that fasten it to the removal tool. Never
lift the engaging hooks by more than approx. 1 mm, in other words only
as far until the retaining plate is released. Otherwise you could damage
the engaging hooks.
Ê Lift the green engaging hooks no more than approx. 1 mm (1) until the
retaining plate is released.
Ê Take the retaining plate out (2) and put it aside.
102
"Opening/closing the housing" on
1
1
Operating manual
CSS components
2
figure 32
RX600 S4